Code Reader 1200 Manual de instalación descargar pdf (Pagina 156)

TC1200 REFERENCE MANUAL

144

5.3.3 Code Verifier

Match String

This is the string used as the match code for code verification. The Match String must be

configured to include start/stop characters and check digits if their transmission is enabled.

It is possible to define the Match string by inserting:

 all printable characters

 non printable ASCII characters

 No wild card characters are supported

To set this feature:

1. Determine the desired character string (max 32).

2. Use the Chart in Appendix C to find the hex equivalent(s)

for the desired character(s).

3. Go to page 60 and scan ENTER/EX

IT PROGRAMMING MODE to enter Programming

Mode.

4. Scan the barcode: SELECT MATCH STRING.

5. Scan the hex equivalent characters

from the keypad in Appendix B that represent the

desired character string in step 1 above.

6. If less than the expected string of 32 characters are selected, scan the ENTER/EXIT

barcode to terminate the string.

7. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.

This completes the procedure.

Wrong Code String

This is the string sent in case of a mismatch (wrong code read).

To set this feature:

1. Determine the desired character string (max 20).

2. Use the Chart in Appendix C to find the hex equivalent(s)

for the desired character(s).

3. Go to page 60 and scan ENTER/EX

IT PROGRAMMING MODE to enter Programming

Mode.

4. Scan the barcode: SELECT WRONG CODE STRING.

5. Scan the hex equivalent characters

from the keypad in Appendix B that represent the

desired character string in step 1 above.

6. If less than the expected string of 20 characters are selected, scan the ENTER/EXIT

barcode to terminate the string.

7. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.

This completes the procedure.

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 175 176

Sin comentarios

Code Reader 1200 Manual de instalación Pagina 156